Monday to Saturday - 8:00 -17:30

If your Toyota Rav4 is running a little hot, it might be time to check the temperature sensor. The sensor is located on the back of the engine, near the firewall. It’s a small black box with two wires coming out of it.To check the sensor, first make sure that the engine is cool.
Then, disconnect the negative battery cable. Next, remove the plastic cover from the sensor. There will be a small metal clip holding it in place.
Use a flathead screwdriver to release the clip and pull the cover off.
The Toyota Rav4 has a temperature sensor located in the engine coolant system. This sensor is used to monitor the coolant temperature and send a signal to the engine control unit (ECU). The ECU then uses this information to adjust the fuel mixture and ignition timing.
If the coolant temperature gets too high, the ECU will richen the fuel mixture and advance the ignition timing. This will help to prevent engine damage from overheating.
How to Replace Ambient Air Temperature Sensor 05-16 Toyota RAV4
Toyota Rav4 Temperature Gauge Not Working
If you have a Toyota Rav4 and the temperature gauge isn’t working, there are a few things that could be causing the problem. First, check to see if the coolant level is low. If it is, add more coolant and see if that fixes the issue.
If not, then it’s possible that the thermostat is stuck in the closed position and needs to be replaced. Finally, if neither of those solutions work, it’s likely that there is a problem with the sensor itself and it will need to be replaced.

Credit: www.amazon.com
Where is My Temperature Sensor Located?
On most devices, the temperature sensor is located near the processor. It helps to regulate the processor’s temperature by monitoring how much heat it’s emitting. If the processor gets too hot, the device will usually throttle back its performance to try and cool things down.
How Do I Reset My Temperature Sensor?
If your home’s temperature sensor is inaccurate, you can reset it in just a few steps. First, remove the batteries from the device and then lightly blow any dust off of the sensing element with compressed air. Once that’s done, put fresh batteries back in the sensor and wait for 24 hours so it can recalibrate itself to the ambient temperature.
After that time has passed, your temperature readings should be much more accurate!
What are the Signs of a Failing Temperature Sensor?
A failing temperature sensor can manifest in a number of ways. The most common symptom is an inaccurate reading from the sensor, which can lead to either overheating or underheating of a system. In some cases, a failing sensor may also stop working altogether, resulting in an inability to monitor temperature changes.
Additionally, faulty sensors may produce false readings even when they are not in use.
What Happens When Coolant Temp Sensor Goes Out?
If your vehicle’s coolant temperature sensor isn’t working properly, it can cause a variety of problems. The most common symptom of a faulty coolant temperature sensor is an illuminated check engine light. Other symptoms may include:
– A drop in fuel efficiency
– An erratic or bouncing idle speed
– Hesitation or stalling when accelerating
– Rough running engine – Engine overheating If you suspect that your coolant temperature sensor may be failing, have the vehicle inspected by a qualified technician.
Conclusion
Are you concerned about your Toyota Rav4’s temperature sensor? If so, you’re not alone. Many Toyota owners have had this problem and have been searching for the sensor’s location.
The good news is that the sensor is located in a fairly easy-to-access spot. It’s on the side of the engine, near the top. You’ll need to remove a few bolts to get to it, but it’s not difficult.
Once you’ve found the sensor, make sure to clean it off and check the connections. If everything looks good, then you should be all set. However, if the problem persists, you may need to replace the entire sensor.